CLI Guide

debug lldp interface
Enable LLDP debugging to display timer events, neighbor additions or deletions, and other information
about incoming and outgoing packets.
Syntax
debug lldp interface {interface | all}{events | packet {brief |
detail} {tx | rx | both}}
To disable debugging, use the no debug lldp interface {interface |
all}{events} {packet {brief | detail} {tx | rx | both}}
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet followed by the slot/port
information.
all (OPTIONAL) Enter the keyword all to display information
on all interfaces.
events (OPTIONAL) Enter the keyword events to display major
events such as timer events.
packet (OPTIONAL) Enter the keyword packet to display
information regarding packets coming in or going out.
brief (OPTIONAL) Enter the keyword brief to display brief
packet information.
detail (OPTIONAL) Enter the keyword detail to display detailed
packet information.
tx (OPTIONAL) Enter the keyword tx to display transmit-only
packet information.
rx (OPTIONAL) Enter the keyword rx to display receive-only
packet information.
both (OPTIONAL) Enter the keyword both to display both receive
and transmit packet information.
Defaults none
Command Modes EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
978
Link Layer Discovery Protocol (LLDP)