CLI Guide

To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the
no default vlan-id vlan-id syntax.
Parameters
vlan-id Enter the VLAN ID number of the VLAN to become the new
Default VLAN. The range is from 1 to 4094. The default is 1.
Defaults The Default VLAN is VLAN 1.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To return VLAN 1 as the Default VLAN, use the (default-vlan-id 1) command.
The Default VLAN contains only untagged interfaces.
Related
Commands
interface vlan — configures a VLAN.
default-vlan disable
Disable the default VLAN so that all switchports are placed in the Null VLAN until they are explicitly
configured as a member of another VLAN.
Defaults Enabled.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The no default vlan disable command is not listed in the running-
configuration, but when the default VLAN is disabled, default-vlan disable is
listed in the running-configuration.
name
Assign a name to the VLAN.
Syntax
name vlan-name
966
Layer 2