CLI Guide

vlan vlan-id Enter the keyword vlan then the VLAN ID. The range is
from 1 to 4094.
ether-type Enter the keywords ether-type then the ether-value in the
XX:XX format.
src-ip address Enter the keywords src-ip then the IP source address in IP
address format.
dest-ip address Enter the keywords dest-ip then the IP destination address
in IP address format.
src-port number Enter the keywords src-port then the source port
number. The range is from 1 to 65536. The default is None.
dest-port number Enter the keywords dest-port then the destination port
number. The range is from 1 to 65536. The default is None.
Command Modes EXEC
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
Because this command calculates based on a Layer 2 hash algorithm, use this
command to display flows for switched Layer 2 packets, not for routed packets
(use the show ip flow command to display routed packets).
The show port-channel-flow command returns the egress port identification
in a given port-channel if a valid flow is entered. A mismatched flow error occurs if
MAC-based hashing is configured for a Layer 2 interface and you are trying to
display a Layer 3 flow.
The output displays three entries:
• Egress port for unfragmented packets.
• In the event of fragmented packets, the egress port of the first fragment.
• In the event of fragmented packets, the egress port of the subsequent
fragments.
NOTE: In the show port-channel–flow command output, the egress port
for an unknown unicast, multicast, or broadcast traffic is not displayed.
Link Aggregation Control Protocol (LACP)
953