CLI Guide

Version Description

8.3.17.0 Supported on the M I/O Aggregator.

Usage Information This command enables (and disables) the collection of CPU traffic statistics from

the time this command is executed (not from system boot). However, excessive

traffic a CPU receives automatically triggers (turn on) the collection of CPU traffic

statics.

To view the traffic statistics, use the show cpu-traffic-stats command.

If the CPU receives excessive traffic, traffic is rate controlled.

NOTE: You must enable this command before the show cpu-traffic-

stats command displays traffic statistics. Dell Networking recommends

disabling debugging (

no debug cpu-traffic-stats) after troubleshooting

is complete.

Commands

show cpu-traffic-stats— displays the cpu traffic statistics.

debug ifm trace-flags

Turn on the IFM internal trace-flags.

Syntax

debug ifm trace-flags trace-flags

To disable this command, use the no debug ifm trace-flags command.

Parameters

trace-flags Enter a hexadecimal number representing the trace-flag.

Defaults None

Command Modes EXEC Privilege

Supported Modes All Modes

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

8.3.17.0 Supported on the M I/O Aggregator.

NOTE: Use this command only when you are working directly with a technical

support representative to troubleshoot a problem. Do not use this command

unless a technical support representative instructs you to do so.

Control and Monitoring