CLI Guide

show io-aggregator isolated-networks
Display the VLANs that are configured to be part of an isolated network on an Aggregator.
Syntax
show io-aggregator isolated-networks
Parameters
isolated-
networks
Specify an isolated network to be configured
vlan vlan-
range
Enter the keyword vlan followed by the member VLANs
using VLAN IDs (separated by commas), a range of VLAN IDs
(separated by a hyphen), a single VLAN ID, or a combination.
For example: VLAN IDs (comma-separated): 3, 4, 6. Range
(hyphen-separated): 5-10. Combination: 3, 4, 5-10, 8.
Defaults None
Command Modes EXEC Privilege
Usage Information This command is used to show the isolated-network feature status and the VLANs
configured for this feature. Show running-config will save this command under io-
aggregator.
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.5(0.0) Supported on the FN I/O Aggregator.
9.5(0.0) Supported on the M I/O Aggregator.
Example
Dell#show io-aggregator isolated-networks
Isolated Network Enabled VLANs : 5-10
Isolated Networks
939