CLI Guide

Isolated Networks

This chapter describes the isolated networks commands in the Dell Networking OS.

io-aggregator isolated-network vlan

Enable the isolated-network functionality for a particular VLAN or a set of VLANs.

Syntax

[no] io-aggregator isolated-network vlan vlan-range

Parameters

isolated-

network

Specify an isolated network to be configured

vlan vlan-

range

Enter the keyword vlan followed by the member VLANs

using VLAN IDs (separated by commas), a range of VLAN IDs

(separated by a hyphen), a single VLAN ID, or a combination.

For example: VLAN IDs (comma-separated): 3, 4, 6. Range

(hyphen-separated): 5-10. Combination: 3, 4, 5-10, 8.

Defaults Not configured.

Command Modes CONFIGURATION

Usage Information To add more VLANs into an isolated network, you can enter this same command at

any later point. The VLANs specified are appended to the existing set of VLANs. To

remove a VLAN or a set of VLANs from an isolated network, use the no form of

command.

Supported Modes All Modes

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.5(0.0) Supported on the FN I/O Aggregator.

9.5(0.0) Supported on the M I/O Aggregator.

Example

Dell(conf)#io-aggregator isolated-network vlan 5-10

938

Isolated Networks