CLI Guide

show isis traffic
This command allows you to display IS-IS traffic interface information.
Syntax
show isis traffic [interface]
Parameters
interface (OPTIONAL) Identifies the interface type slot/port as one of
the following:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show isis traffic command shown in the
following example.
Item Description
Level-1/Level-2
Hellos (sent/rcvd)
Displays the number of Hello packets sent and received.
PTP Hellos (sent/
rcvd)
Displays the number of point-to-point Hellos sent and
received.
Level-1/Level-2
LSPs sourced
(new/refresh)
Displays the number of new and refreshed LSPs.
Level-1/Level-2
LSPs flooded
(sent/rcvd)
Displays the number of flooded LSPs sent and received.
Level-1/Level-2
LSPs CSNPs (sent/
rcvd)
Displays the number of CSNP LSPs sent and received.
Level-1/Level-2
LSPs PSNPs (sent/
rcvd)
Displays the number of PSNP LPSs sent and received.
Intermediate System to Intermediate System (IS-IS)
935