CLI Guide

• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Use this command to confirm that the neighbor adjacencies are operating
correctly. If you suspect that they are not, you can verify the specified area
addresses of the routers by using the show isis neighbors command.
The following describes the show isis neighbors command shown in the
following example.
Field Description
System Id The value that identifies a system in an area.
Interface The interface, slot, and port in which the router was
discovered.
State The value providing status about the adjacency state. The
range is Up and Init.
Type This value displays the adjacency type (Layer 2, Layer 2 or
both).
Priority IS-IS priority the neighbor advertises. The neighbor with
highest priority becomes the designated router for the
interface.
Uptime Displays the interfaces uptime.
Circuit Id The neighbor’s interpretation of the designated router for
the interface.
Example
The bold sections below identify that Multi-Topology IS-IS is enabled.
Dell#show isis neighbors
System Id Interface State Type Priority Uptime Circuit Id
TEST Gi 7/1 Up L1L2
(M) 127 09:28:01 TEST.02
!
Dell#show isis neighbors detail
Intermediate System to Intermediate System (IS-IS)
933