CLI Guide

• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example (Router-
Isis)
The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode.
Dell(conf-router_isis)#show config
!
router isis
clns host ISIS 49.0000.0001.F100.E120.0013.00
log-adjacency-changes
net 49.0000.0001.F100.E120.0013.00
!
address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
Example (Address-
Family_IPv6)
The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode.
Dell(conf-router_isis-af_ipv6)#show conf
!
address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
show isis database
Display the IS-IS link state database.
Syntax
show isis database [level-1 | level-2] [local] [detail |
summary] [lspid]
Parameters
level-1 (OPTIONAL) Displays the Level 1 IS-IS link-state database.
level-2 (OPTIONAL) Displays the Level 2 IS-IS link-state database.
local (OPTIONAL) Displays local link-state database information.
Intermediate System to Intermediate System (IS-IS)
927