CLI Guide

multi-topology
Enables multi-topology IS-IS. It also allows enabling/disabling of old and new style TLVs for IP prefix
information in the LSPs.
Syntax
multi-topology [transition]
To return to a single topology configuration, use the no multi-topology
[transition] command.
Defaults Disabled
Command Modes CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
net
To configure an IS-IS network entity title (NET) for a routing process, use this mandatory command. If
you did not configure a NET, the IS-IS process does not start.
Syntax
net network-entity-title
To remove a net, use the no net network-entity-title command.
Parameters
network-entity-
title
Specify the area address and system ID for an IS-IS routing
process. The first 1 to 13 bytes identify the area address. The
next 6 bytes identify the system ID. The last 1 byte is the
selector byte, always identified as zero zero (00). This
argument can be applied to an address or a name.
Defaults Not configured.
Command Modes ROUTER ISIS
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Intermediate System to Intermediate System (IS-IS)
919