CLI Guide

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

9.2(0.0) Introduced on the M I/O Aggregator.

8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information When you enable the iSCSI feature using the iscsi enable command, flow

control settings are set to rx on tx off on all interfaces.

iscsi priority-bits

Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.

Syntax

iscsi priority-bits priority-bitmap

To remove the configured iSCSI priority, use the no iscsi priority-bits

command.

Parameters

priority-bitmap Enter the priority-bitmap range. The range is from 1 to FF.

Defaults 0x10

Command Modes PROTOCOL LLDP