CLI Guide

Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
show ip bgp ipv6 unicast neighbors
Allows you to view the information exchanged by BGP neighbors.
Syntax
show ip bgp ipv6 unicast neighbors [ipv6-address prefix-length
[advertised-routes | dampened-routes | detail | flap-statistics
| routes]]
Parameters
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
advertised-routes (OPTIONAL) Enter the keywords advertised-routes to
view only the routes the neighbor sent.
dampened-routes (OPTIONAL) Enter the keywords dampened-routes to view
information on dampened routes from the BGP neighbor.
flap-statistics (OPTIONAL) Enter the keywords flap-statistics to view
flap statistics on the neighbor’s routes.
detail (OPTIONAL) Display detailed neighbor information.
routes (OPTIONAL) Enter the keyword routes to view only the
neighbor’s feasible routes.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip bgp ipv6 unicast neighbors
command shown in the Example below.
868
IPv6 Border Gateway Protocol (IPv6 BGP)