CLI Guide

Usage Information
The first time you enter this command it configures the neighbor as a route
reflector and members of the route-reflector cluster. Internal BGP (IBGP) speakers
do not need to be fully meshed if you configure a route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route
reflector.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ipv6-address [route-map map-name]
To remove a network, use the no network ipv6-address [route-map map-
name] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name
of an established route map.
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The software resolves the network address configured by the network command
with the routes in the main routing table to ensure that the networks are reachable
using non-BGP routes and non-default routes.
Related
Commands
redistribute — redistributes routes into BGP.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
IPv6 Border Gateway Protocol (IPv6 BGP)
861