CLI Guide

usbflash After entering the keyword usbflash you can either follow

it with the location of the source file in this form://

filepath

, or press Enter to launch a prompt sequence.

A: Enter this keyword to upgrade the bootflash partition A.

B: Enter this keyword to upgrade the bootflash partition B.

Defaults none

Command Modes EXEC Privilege

Supported Modes All Modes

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.4(0.0) Supported on the FN I/O Aggregator.

8.3.17.0 Supported on the M I/O Aggregator.

Usage Information You must reload Dell Networking OS after executing this command. Use the

command upgrade system stack-unit to copy Dell Networking OS from the

management unit to one or more stack members.

Example

Dell#upgrade system ?

flash: Copy from flash file system (flash://filepath)

ftp: Copy from remote file system, IPv4 or IPv6,

(ftp:/

/userid:password@hostip/filepath)

scp: Copy from remote file system, IPv4 or IPv6,

(scp:/

/userid:password@hostip/filepath)

stack-unit Sync image to the stack-unit

tftp: Copy from remote file system, IPv4 or IPv6,

(tftp:/

/hostip/filepath)

usbflash: Copy from usbflash file system (usbflash://

filepath)

Dell#

verify

Validate the software image on the flash drive after the image has been transferred to the system, but

before the image has been installed.

Syntax verify { md5 | sha256 }[ flash:// ] img-file [hash-value]

Parameters

md5 Enter the md5 keyword to use the MD5 message-digest

algorithm.

File Management