CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
neighbor distribute-list
Distribute BGP information using an established prefix list.
Syntax
neighbor {ipv6-address | peer-group-name} distribute-list
prefix-list-name {in | out}
To delete a neighbor distribution list, use the no neighbor {ipv6-address |
peer-group-name} distribute-list prefix-list-name {in | out}
command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-name Enter the name of the peer group.
prefix-list-name Enter the name of an established prefix list. If the prefix list is
not configured, the default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
neighbor filter-list — assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map — assigns a route map to a neighbor or peer group.
neighbor filter-list
Configure a BGP filter based on the AS-PATH attribute.
Syntax
neighbor [ipv6-address | peer-group-name] filter-list aspath
access-list-name [in | out]
856
IPv6 Border Gateway Protocol (IPv6 BGP)