CLI Guide

upgrade boot

Upgrade the bootflash image or bootselector image.

Syntax

upgrade boot {all | bootflash-image | bootselector-image}

stack-unit {0-5 | all} {booted | flash: |ftp: | tftp: |

usbflash:} (A: | B:}

Parameters

all Enter the keyword all to change both the bootflash and

bootselecter images.

bootflash-image Enter the keywords bootflash-image to change the

bootflash image.

bootselector-

image

Enter the keywords bootselector-image to change the

bootselector image.

0–5 Enter the keyword 0–5 to upgrade only the mentioned

stack-unit.

all Enter the keyword all to upgrade all the member stack-

units.

booted Enter the keyword booted to upgradefrom the current

image in the M I/O Aggregator.

ftp: After entering the keyword ftp:, you can either follow it

with the location of the source file in this form: //

userid:password@hostip/filepath

or press Enter to

launch a prompt sequence.

tftp: After entering the keyword tftp:, you can either follow it

with the location of the source file in this form: //

hostlocation/filepath

or press Enter to launch a

prompt sequence.

flash: After entering the keyword flash:, you can either follow it

with the location of the source file in this form: //

filepath

or press Enter to launch a prompt sequence.

usbflash: After entering the keyword usbflash:, you can either

follow it with the location of the source file in this form: //

filepath

or press Enter to launch a prompt sequence.

A: Enter this keyword to upgrade the bootflash partition A.

B: Enter this keyword to upgrade the bootflash partition B.

Defaults none

Command Modes EXEC Privilege

Supported Modes All Modes

File Management