CLI Guide

Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information After you configure a peer group as passive, you must assign it a subnet using the
neighbor subnet command.
Related
Commands
neighbor subnet — assigns a subnet to a dynamically configured BGP neighbor.
neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
Syntax
neighbor {ipv6-address | peer-group-name} remote-as number
To delete a remote AS entry, use the no neighbor {ipv6-address | peer-
group-name} remote-as number command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-name Enter a text string up to 16 characters long as the name of
the peer group.
number Enter a number of the AS. The range is from 1 to 65535.
Defaults Not configured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If the number parameter is the same as the AS number used in the router bgp
command, the remote AS entry in the neighbor is considered an internal BGP peer
entry.
This command creates a peer and the newly created peer is disabled (shutdown).
Related
Commands
router bgp — enters the ROUTER BGP mode and configure routes in an AS.
818
IPv6 Border Gateway Protocol (IPv6 BGP)