CLI Guide

show ip bgp ipv6 unicast neighbors — views BGP neighbors configurations.
neighbor peer-group (creating group)
Allows you to create a peer group and assign it a name.
Syntax
neighbor peer-group-name peer-group
To delete a peer group, use the no neighbor peer-group-name peer-group
command.
Parameters
peer-group-name Enter a text string up to 16 characters long as the name of
the peer group.
Defaults Not configured.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When a peer group is created, it is disabled (shut mode).
Related
Commands
neighbor peer-group (assigning peers) — assigns routers to a peer group.
neighbor remote-as — assigns a indirectly connected AS to a neighbor or peer
group.
neighbor shutdown — disables a peer or peer group.
neighbor peer-group passive
Enable passive peering on a BGP peer group; that is, the peer group does not send an OPEN message,
but does respond to one.
Syntax
neighbor peer-group-name peer-group passive
To delete a passive peer-group, use the no neighbor peer-group-name
peer-group passive command.
Parameters
peer-group-name Enter a text string up to 16 characters long as the name of
the peer group.
Defaults Not configured.
Command Modes ROUTER BGP
IPv6 Border Gateway Protocol (IPv6 BGP)
817