CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
router bgp — enters ROUTER mode on the switch.
distance bgp
Configure three administrative distances for routes.
Syntax
distance bgp external-distance internal-distance local-distance
To return to default values, use the no distance bgp command.
Parameters
external-distance Enter a number to assign to routes learned from a neighbor
external to the AS. The range is from 1 to 255. The default is
20.
internal-distance Enter a number to assign to routes learned from a router
within the AS. The range is from 1 to 255. The default is 200.
local-distance Enter a number to assign to routes learned from networks
listed in the network command. The range is from 1 to 255.
The default is 200.
Defaults
• external-distance = 20
• internal-distance = 200
• local-distance = 200
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
CAUTION: Dell Networking recommends that you do not change the
administrative distance of internal routes. Changing the administrative
distances may cause routing table inconsistencies.
The higher the administrative distance assigned to a route means that your
confidence in that route is low. Routes assigned an administrative distance of 255
are not installed in the routing table.
806
IPv6 Border Gateway Protocol (IPv6 BGP)