CLI Guide

stale-path-time
seconds
Enter the keywords stale-path-time then the maximum
number of seconds to wait before restarting a peer’s stale
paths. The default is 360 seconds.
role receiver-only Enter the keywords role receiver-only to designate the
local router to support graceful restart as a receiver only.
Defaults As above
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This feature is advertised to BGP neighbors through a capability advertisement. In
Receiver Only mode, BGP saves the advertised routes of peers that support this
capability when they restart.
bgp log-neighbor-changes
Enable logging of BGP neighbor resets.
Syntax
bgp log-neighbor-changes
To disable logging, use the no bgp log-neighbor-changes command.
Defaults Enabled.
Command Modes ROUTER BGP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The bgp log-neighbor-changes command appears in the show config
command output.
Related
Commands
show config — views the current configuration.
bgp non-deterministic-med
Compare MEDs of paths from different autonomous systems (ASs).
Syntax
bgp non-deterministic-med
IPv6 Border Gateway Protocol (IPv6 BGP)
789