CLI Guide

Parameters
unit-number Enter the stack unit’s ID number. The range is from 0 to 5.
port-set Enter the keyword Port Set.
summary (OPTIONAL) Enter the keyword summary to display a table
listing network prefixes and the total number prefixes which
can be entered into the IPv6 CAM.
index (OPTIONAL) Enter the index in the IPv6 CAM.
ipv6-address Enter the IPv6 address in the x:x:x:x::x/n format to display
networks that have more specific prefixes. The range is
from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
NOTE: If a route has a mask greater than 64, no output is displayed and no
output is displayed for show ipv6 cam stack-unit unit-number port-
set {0-1} ipv6-address, but an equivalent /64 entry would be listed in
the
show ipv6 cam stack-unit unit-number port-set {0-0}
output. Similarly, if there is more than one ECMP object with a destination
route that has a mask greater than 64, if the first 64 bits in the destination
routes of the ECMP objects are the same, only one route is installed in CAM
even though multiple ECMP path entries exist.
show ipv6 control-plane icmp
Displays the status of the icmp control-plane setting for the error eate limit setting.
Syntax
show ipv6 control-plane icmp
Default 100
Command Modes EXEC
768
IPv6 Basics