CLI Guide

Dell(conf)#int ten 0/6

Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64

ipv6 control-plane icmp error-rate-limit

Configure the maximum number of ICMP error packets per second that can be sent per second.

Syntax

ipv6 control-plane icmp error-rate-limit {1-200}

To restore the default value, use the no ipv6 control-plane icmp error-

rate-limit command.

Parameters

pps Enter the maximum number of error packets generated per

second. The range is from 1 to 200, where 0 disables the

rate-limiting.

Default 100 pps

Command Modes CONFIGURATION

Supported Modes Full–Switch

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.

ipv6 flowlabel-zero

Configure system to set the flow label field in the packets to zero.

Syntax

ipv6 flowlabel-zero

To disable the 0 from being set in the field and allow the rotocol operations to fill

the field, use the no ipv6 flowlabel-zero command.

Default Disabled