CLI Guide

To remove the management traffic crypto policy, use the no management
crypto-policy name command.
Parameters
name Enter the name for the crypto policy.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
match
Match a sequence number to the transmission control protocol (TCP)/user datagram protocol (UDP)
packets.
Syntax
match seq-num {tcp | udp} {ipv6 | ip} port-num dest-ip dest-
port-num
To remove the match filter for the crypto map, use the no match seq-num
command.
Parameters
seq-num Enter the match command sequence number. The range is
from 0 to 255.
tcp Enter the keyword tcp to configure a TCP access list filter.
udp Enter the keyword udp to configure a UDP access list filter.
ipv6 Enter the source IPv6 address.
ip Enter the source IPv4 address.
port-num Enter the source port number. The range is from 0 to 65535
dest-ip Enter the destination IP address.
dest-port-num Enter the destination port number. The range is from 0 to
65535.
Defaults none
Command Modes CONFIG-CRYPTO-POLICY
Supported Modes Full–Switch
Internet Protocol Security (IPSec)
741