CLI Guide

summary (OPTIONAL) Enter the keyword summary to view a table
listing route prefixes and the total number routes which can
be entered in to CAM.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip cam command shown in the following
example.
Field Description
Destination Displays the destination route of the index.
EC Displays the number of equal cost multipaths (ECMP)
available for the default route for non-Jumbo line cards. For
Jumbo line cards, displays 0,1 when ECMP is more than
eight.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 otherwise.
C Displays the CPU bit. 1 indicates that a packet hitting this
entry is forwarded to the CP or RP2, depending on Egress
port.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of
a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the
entry to determine the interface. For example, in the entry
17cl CP, the CP is the pertinent portion.
• CP = control processor
• Gi = Gigabit Ethernet interface
• Te = 10–Gigabit Ethernet interface
Example
Dell#show ip cam stack-unit 0 port-set 0 10.10.10.10/32 longer-
prefixes
Destination EC CG V C VId Mac-Addr Port
----------------- -- -- - ------ --------------------
IPv4 Routing
721