CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
management route
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ipv4-address | ipv6–address}/mask{forwarding-
router-address | managementethernet}
Parameters
{ipv4-address |
ipv6–address}/
mask
Enter an IPv4 address (A.B.C.D) or the IPv6 address followed
by the prefix-length for the IP address of the management
interface.
forwarding-
router-address
Enter an IPv4 address of a forwarding router.
managementethe
rnet
Enter the keyword managementethernet for the
Management interface.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
Usage Information When a static route (or a protocol route) overlaps with Management static route,
the static route (or a protocol route) is preferred over the Management Static route.
Also, Management static routes and the Management Connected prefix are not
reflected in the hardware routing tables. Separate routing tables are maintained for
IPv4 management routes. This command manages both tables.
show arp
Displays the ARP table.
Syntax
show arp [interface interface ] [dynamic] [summary]
716
IPv4 Routing