CLI Guide

• Transmission Control Protocol (tcp) but not on the rst, syn, or urg bits
• User Datagram Protocol (udp)
In the case of ambiguous access control list rules, the debug ip packet
access-control command is disabled. A message appears identifying the error
(refer to the Example below).
Example (Error
Messages)
Dell#debug ip packet access-group test
%Error: port operator GT not supported in access-list debug
%Error: port operator LT not supported in access-list debug
%Error: port operator RANGE not supported in access-list debug
%Error: port operator NEQ not supported in access-list debug
Dell#00:10:45: %RPM0-P:CP
%IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not
supported in access-list debug, access-list debugging is
turned off
Dell#
ip address
Assign a primary and secondary IP address to the interface.
Syntax
ip address ip-address mask [secondary]
To delete an IP address from an interface, use the no ip address [ip-
address] command.
Parameters
ip-address Enter an IP address in dotted decimal format.
mask Enter the mask of the IP address in slash prefix format (for
example, /24).
secondary (OPTIONAL) Enter the keyword secondary to designate the
IP address as the secondary address.
Defaults Not configured.
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information You must be in INTERFACE mode before you add an IP address to an interface.
Assign an IP address to an interface prior to entering ROUTER OSPF mode.
IPv4 Routing
703