CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#debug ip udp-helper
UDP helper debugging is on
01:20:22: Pkt rcvd on Te 4/1 with IP DA (0xffffffff) will be
sent on Te 4/2 Te 4/3
Vlan 3
01:44:54: Pkt rcvd on Te 5/1 is handed over for DHCP
processing.
Related
Commands
ip udp-broadcast-address — configures a UDP IP address for broadcast.
ip udp-helper udp-port — enables the UDP broadcast feature on an interface.
show ip udp-helper — displays the configured UDP helper(s) on all interfaces.
ip udp-broadcast-address
Configure an IP UDP address for broadcast.
Syntax
ip udp-broadcast-address address
To delete the configuration, use the no ip udp-broadcast-address address
command.
Parameters
address Enter an IP broadcast address in dotted decimal format
(A.B.C.D).
Defaults Not configured.
Command Modes INTERFACE (config-if)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Enter an IP broadcast address in dotted decimal format
(A.B.C.D).
Usage Information When a UDP broadcast packet is flooded out of an interface, and the outgoing
interface is configured using this command, the outgoing packet’s IP destination
address is replaced with the configured broadcast address.
676
Interfaces