CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
Example
Dell(conf)#port-channel failover-group
Dell(conf-po-failover-grp)#group 1 port-channel 1 port-channel
2
Dell(conf-po-failover-grp)#
Related
Commands
port-channel failover-group — accesses PORT-CHANNEL FAILOVER-GROUP
mode to configure a LAG failover group.
show interfaces port-channel — displays information on configured Port Channel
groups.
interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing physical interfaces on
the Aggregator.
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-
number command.
Parameters
channel-number For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by
using the switchport command) or Layer 3 mode (by configuring an IP address).
You can add a Port Channel in Layer 2 mode to a VLAN.
Interfaces
667