CLI Guide

The system must be reloaded after issuing the CLI for the change to take effect.
wavelength
Set the wavelength for tunable 10–Gigabit SFP+ optics.
Syntax
wavelength
To retain the existing wavelength, use the no wavelength command.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6000, S6000–ON, S5000, S4810,
S4820T, S3048–ON, S4048–ON, M I/O Aggregator, FN I/O
Module, MXL, C9010, S3100 series, and Z9100-ON.
Usage Information
The wavelength can be configured only on a tunable 10–Gigabit SFP+ optic. The
wavelength range is from 1528.3 nm to 1568.77nm.
If you configure the wavelength on a non-tunable optic, there is no change to the
existing wavelength. The configured wavelength is saved in the running
configuration and is applicable, when a tunable optic is used.
If you do not configure the wavelength on an inserted tunable optic, the existing
wavelength is used.
Example
The following example shows the wavelength set for a tunable 10–Gigabit SFP+
optic:
Related
Commands
• show config — displays the interface configuration.
Port Channel Commands
A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a single link
according to IEEE 802.3ad. In Dell Networking OS, a LAG is referred to as a Port Channel.
• For the Aggregator, the maximum port channel ID is 128 and the maximum members per port
channel is 4.
664
Interfaces