CLI Guide

Example
Dell(conf-if-range-te-0/6)#show range
interface tengigabitethernet 0/6
Dell(conf-if-range-te-0/6)#
Related
Commands
interface — configures a physical interface on the switch.
show ip interface — displays Layer 3 information about the interfaces.
show interfaces — displays information on a specific physical interface or virtual
interface.
shutdown
Disable an interface.
Syntax
shutdown
To activate an interface, use the no shutdown command.
Defaults The interface is disabled.
Command Modes INTERFACE
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information
The shutdown command marks a physical interface as unavailable for traffic. To
discover if an interface is disabled, use the show ip interface command.
Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes different behavior. When a VLAN is
disabled, the Layer 3 functions within that VLAN are disabled. Layer 2 traffic
continues to flow. Entering the shutdown command on a port channel disables all
traffic on the port channel and the individual interfaces within the port channel. To
enable a port channel, you must enter no shutdown on the port channel interface
and at least one interface within that port channel.
The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port channel.
Related
Commands
vlan tagged —Test the condition of copper cables on 100/1000/10G Base-T
modules.
interface vlan — Creates a VLAN.
Interfaces
661