CLI Guide

802.1QTagged: True
Vlan membership:
Q Vlans
T 1001
Name: TenGigabitEthernet 2/11
802.1QTagged: True
Vlan membership:
Q Vlans
T 1001
Dell#
Related
Commands
show ip interface — displays Layer 3 information about the interfaces.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the
transceiver’s serial number.
Syntax
show interfaces tengigabitethernet slot/port transceiver
Parameters
tengigabitethernet For a 10G interface, enter the keyword
tengigabitethernet then the slot/port information.
NOTE: This command also enables you to view
information corresponding to a range of ports.
However, for Open Networking (ON) platforms the
notation for specifying port range in the command is
different from how you specify in non-ON platforms.
• For non-ON platforms, you can specify multiple
ports as slot/port-range. For example, if you
want to display information corresponding to all
ports between 1 and 4, specify the port range as
show interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as
slot/port/[subport] - slot/port/
[subpot]. For example, if you want to display
information corresponding to all ports between 1
and 4, specify the port range as
show interfaces
interface-type 1/1/1 - 1/4/1.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes Full–Switch
Interfaces
655