CLI Guide

Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the
interface configurations corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Example
Dell#sh interfaces status
Port Description Status Speed Duplex Vlan
Te 2/1 Down Auto Auto --
Te 2/2 Down Auto Auto --
Te 2/3 Down Auto Auto --
Te 2/4 Down Auto Auto --
Te 2/5 Down Auto Auto --
Te 2/6 Down Auto Auto --
Te 2/7 Down Auto Auto --
Te 2/8 Down Auto Auto --
Te 2/9 Up 10000 Mbit Full 1001
Te 2/10 Down Auto Auto --
Te 2/11 Up 10000 Mbit Full 1001
Te 2/12 Down Auto Auto --
Dell#
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode
interfaces’ IEEE 802.1Q tag status and VLAN membership.
Syntax
show interfaces switchport [interface | stack-unit unit-id ]
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• Enter the keyword backup to view the backup interface
for this interface.
Interfaces
653