CLI Guide

show interfaces description
Display the descriptions configured on the interface.
Syntax
show interfaces [interface] description
Parameters
interface Enter one of the following keywords and slot/port or
number information:
• For the management interface on the stack unit enter
the keyword ManagementEthernet followed by the
slot/port information. The slot range is 0-0 and the port
range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For VLAN interfaces, enter the keyword vlan followed
by a number from 1 to 4094.
NOTE: This command also enables you to view
information corresponding to a range of ports.
• You can specify multiple ports as slot/port-
range
. For example, if you want to display
information corresponding to all ports between 1
and 4, specify the port range as show interfaces
interface-type 1/1 - 4.
Command Modes
• EXEC
• EXEC Privilege
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the
interface configurations corresponding to a range of ports.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information The following describes the show interfaces description command shown
in the Example below.
Field Description
Interface Displays the type of interface and associated slot and port
number.
OK? Indicates if the hardware is functioning properly.
650
Interfaces