CLI Guide

Line Description
displayed in bits, packets per second, and percent of line
rate.
Time since... Elapsed time since the last interface status change
(hh:mm:ss format).
Usage Information
The interface counter “over 1023-byte pkts” does not increment for packets in the
range 9216 > x <1023.
The Management port is enabled by default (no shutdown). If necessary, use the
ip address command to assign an IP address to the Management port.
Example
(ManagementEther
net)
Dell#show interface managementethernet ?
0/0 Management Ethernet interface number
Dell#show interface managementethernet 0/0
ManagementEthernet 0/0 is up, line protocol is up
Hardware is DellForce10Eth, address is 00:1e:c9:f1:00:05
Current address is 00:1e:c9:f1:00:05
Pluggable media not present
Interface index is 235159752
Internet address is 10.11.209.87/16
Mode of IP Address Assignment : MANUAL
DHCP Client-ID: mgmt001ec9f10005
Virtual-IP is not set
Virtual-IP IPv6 address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 100 Mbit, Mode full duplex
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 5d4h57m
Queueing strategy: fifo
Input 3448753 packets, 950008323 bytes, 3442163 multicast
Received 0 errors, 0 discarded
Output 4627 packets, 814226 bytes, 0 multicast
Output 0 errors, 0 invalid protocol
Related
Commands
show interfaces configured — Displays any interface with a non-default
configuration.
show interfaces port-channel — Displays information on all interfaces on a specific
stack unit.
show interfaces switchport — Displays Layer 2 information about the interfaces.
show inventory — Displays the I/O Aggregator type, components (including media),
Dell Networking OS version including hardware identification numbers and
configured protocols.
show ip interface — Displays Layer 3 information about the interfaces.
show memory — Displays the stack unit(s) status.
show interfaces status — Displays all interfaces configured using the interface
range command.
Interfaces
647