CLI Guide

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The output of the show interfaces command displays the configured rate
interval, along with the collected traffic data.
Related
Commands
show interfaces — displays information on physical and virtual interfaces.
remote-fault-signaling rx
Brings the interface up or down when a Remote Fault Indication (RFI) error is detected.
Syntax
remote-fault-signaling rx {on | off}
Parameters
on Brings the interface up when an RFI error is detected.
off Brings the interface down when an RFI error is detected.
Defaults ON.
Command Modes INTERFACE CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL switch.
Usage Information
By default, the switch processes the RFI errors transmitted by remote peers and
brings down the interface when an RFI error is detected.
Example
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
show config
Display the interface configuration.
Syntax
show config
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Interfaces
643