CLI Guide

into consideration when doing hash computations. This
option is disabled by default.
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
By default, Dell Networking OS distributes incoming traffic based on a hash
algorithm using the following criteria:
• IP source address
• IP destination address
• TCP/UDP source port
• TCP/UDP destination port
load-balance hg
Choose the traffic flow parameters the hash calculation uses while distributing the traffic across internal
higig links.
Syntax
[no] load-balance hg { ip-selection | ipv6-selection [source-ip
| source-ipv6 | source-port-id | source-module-id | dest-ip |
dest-ipv6 | dest-port-id | dest-module-id | protocol | vlan |
L4-source-port | L4-dest-port ] | mac [source-mac | source-
port-id | source-module-id | dest-mac | dest-port-id | dest-
module-id | vlan | ethertype | source-dest-mac ] | tunnel
[ipv4-over-ipv4 | ipv4-over-gre-ipv4 | mac-in-mac]}
Parameters
ip-selection |
ipv6-selection
[source-ip |
source-ipv6 |
source-port-id |
source-module-id
| dest-ip | dest-
ipv6 | dest-port-id
| dest-module-id |
protocol | vlan |
L4-source-port |
L4-dest-port ]
To use IPv4 key fields in hash computation, enter the
keyword ip-selection then one of the parameters. To use
IPv6 key fields in hash computation, enter the keyword
ipv6-selection then one of the parameters.
• source-ip — Use IPv4 src-ip field in hash calculation.
• source-ipv6 — Use IPv6 src-ip field in hash calculation
• source-port-id — Use src-port-id field in hash
calculation.
• source-module-id — Use src-module-id field in hash
calculation.
• dest-ip — Use IPv4 dest-ip field in hash calculation
• dest-ipv6 — Use IPv6 dest-ip field in hash calculation
634
Interfaces