CLI Guide

interface vlan
Configure a VLAN. Configure the default VLAN to enable Static or DCHP IP configuration. You can
configure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
vlan-id Enter 1 for the default VLAN. Enter a number as the VLAN
identifier. The range is from 1 to 4096.
Defaults Not configured, except for the default VLAN, which is configured as VLAN 1.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information For more information about VLANs and the commands to configure them, refer to
Virtual LAN (VLAN) Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC/IP ACLs are
not supported.
Examples
Dell(conf)#int vlan 1
Dell(conf-if-vl-1)#
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related
commands
show vlan — Displays the current VLAN configuration on the switch.
vlan tagged — Adds a Layer 2 interface to a VLAN as a tagged interface.
vlan untagged — Adds a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled.
Syntax
intf-type cr4 autoneg
If you configure intf-type cr4 autoneg, use the no intf-type cr4
autoneg command to set the interface type as cr4 with autonegotiation disabled.
Defaults Not configured
Interfaces
631