CLI Guide

Parameters
slot/port Enter the keyword ManagementEthernet, then the slot
number (0) and port number zero (0).
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4.(0.0) Supported on the FN I/O Aggregator and M I/O Aggregator.
Usage Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). To assign an IP
address to the Management port, use the ip address command.
Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#
interface null
Configure a Null interface on the switch.
Syntax
interface null number
Parameters
number Enter zero (0) as the Null interface number.
Defaults Not configured; number = 0
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information You cannot delete the Null interface. The only configuration command possible in
a Null interface is ip unreachables.
Example
Dell(conf)#interface null 0
Dell(conf-if-nu-0)#
626
Interfaces