CLI Guide

Example
Dell(conf)#interface tengig 0/1
Dell(conf-if-te-0/1)#exit#
Related
Commands
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
interface loopback
Configure a Loopback interface.
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number
command.
Parameters
number Enter a number as the interface number. The range is from
0 to 16383.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf)#interface loopback 1655
Dell(conf-if-lo-1655)#
Related
Commands
interface — configures a physical interface.
interface null — configures a Null interface.
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
interface ManagementEthernet
Configure the Management port on the system.
Syntax
interface ManagementEthernet slot/port
Interfaces
625