CLI Guide

duplex (1000/10000 Interfaces)
Configure duplex mode on any physical interfaces where the speed is set to 1000/10000.
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the physical interface to
transmit only in one direction.
full Enter the keyword full to set the physical interface to
transmit in both directions.
Defaults Not configured.
Command Modes INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command applies to any physical interface with speed set to 1000/10000.
NOTE: Starting with the Dell Networking OS version 7.8.1.0, when you use a
copper SFP2 module with catalog number GP-SFP2-1T in the S25P module,
you can manually set its speed with the speed command. When you set the
speed to 10 Mbps or 100 Mbps, you can also execute the duplex command.
Related
Commands
speed (for 1000/10000/auto interfaces) — sets the speed on the Base-T Ethernet
interface.
negotiation auto — enables or disables auto-negotiation on an interface.
flowcontrol
Controls how the system responds to and generates 802.3x pause frames on 10G and 40Gig stack units.
Syntax
flowcontrol rx {off | on} tx {off | on} threshold
Parameters
rx on Enter the keywords rx on to process the received flow
control frames on this port. This is the default value for the
receive side.
rx off Enter the keywords rx off to ignore the received flow
control frames on this port.
Interfaces
621