CLI Guide

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The access list accepted is an extended ACL. To block IGMP reports from hosts, on
a per-interface basis based on the group address and source address that you
specify in the access list, use this feature.
ip igmp group-join-limit
To limit the number of IGMP groups that can be joined in a second, use this feature.
Syntax
ip igmp group-join-limit number
Parameters
number Enter the number of IGMP groups permitted to join in a
second. The range is from 1 to 10000.
Defaults none
Command Modes CONFIGURATION (conf-if-interface-slot/port)
Supported Modes Programmable-Mux (PMUX)
Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Supported on the FN I/O Aggregator.
9.2(0.0) Introduced on the M I/O Aggregator.
ip igmp querier-timeout
Change the interval that must pass before a multicast router decides that there is no longer another
multicast router that should be the querier.
Syntax
ip igmp querier-timeout seconds
To return to the default value, use the no ip igmp querier-timeout
command.
606
Internet Group Management Protocol (IGMP)