CLI Guide

a Join message is not received before the Leave time expires, the GARP
application entity removes the attribute information as requested.
• Leave All Timer — The Leave All timer starts when a GARP application entity
starts. When this timer expires, the entity sends a
Leave-all message so that
other entities can reregister their attribute information. Then the Leave-all
time begins again.
Related
Commands
show garp timers — displays the current GARP times.
gvrp enable
Enable GVRP on physical interfaces and LAGs.
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults Disabled.
Command Modes CONFIGURATION-INTERFACE
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
disable — globally disables GVRP.
gvrp registration
Configure the GVRP register type.
Syntax
gvrp registration {fixed | normal | forbidden}
To return to the default, use the gvrp register normal command.
Parameters
fixed Enter the keyword fixed then the VLAN range in a comma-
separated VLAN ID set.
normal Enter the keyword normal then the VLAN range in a
comma-separated VLAN ID set. This setting is the default.
GARP VLAN Registration (GVRP)
597