CLI Guide

protocol gvrp — access GVRP protocol.
garp timers
Set the intervals (in milliseconds) for sending GARP messages.
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave |
leave-all} command.
Parameters
join Enter the keyword join then the number of milliseconds to
configure the join time. The range is from 100 to 147483647
milliseconds. The default is 200 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave Enter the keyword leave then the number of milliseconds
to configure the leave time. The range is from 100 to
2147483647 milliseconds. The default is 600 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave-all Enter the keywords leave-all then the number of
milliseconds to configure the leave-all time. The range is
from 100 to 2147483647 milliseconds. The default is 1000
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Defaults As above.
Command Modes CONFIGURATION-GVRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
• Join Timer — Join messages announce the willingness to register some
attributes with other participants. For reliability, each GARP application entity
sends a Join message twice and uses a join timer to set the sending interval.
• Leave Timer — Leave announces the willingness to de-register with other
participants. Together with Join, Leave messages help GARP participants
complete attribute reregistration and de-registration. The leave timer starts after
receipt of a leave message sent for de-registering some attribute information. If
596
GARP VLAN Registration (GVRP)