CLI Guide

To disable debugging, use the no debug gvrp {config | events | pdu}
command.
Parameters
config Enter the keyword config to enable debugging on the
GVRP configuration.
event Enter the keyword event to enable debugging on the
JOIN/LEAVE events.
pdu Enter the keyword pdu then one of the following Interface
keywords and slot/port or number information:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults Disabled.
Command Modes EXEC
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
disable
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults Enabled.
Command Modes CONFIGURATION-GVRP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
gvrp enable — enables GVRP on physical interfaces and LAGs.
GARP VLAN Registration (GVRP)
595