CLI Guide

Parameters
master Enter the keyword master to set the Ring node to Master
mode.
transit Enter the keywordtransit to set the Ring node to Transit
mode.
Defaults Mode None
Command Modes CONFIGURATION (conf-frrp)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
protocol frrp
Enter the Resilient Ring Protocol and designate a ring identification.
Syntax
protocol frrp {ring-id}
To exit the ring protocol, use the no protocol frrp {ring-id} command.
Parameters
ring-id Enter the ring identification number. The range is from 1 to
255.
Defaults none
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command places you into the resilient ring protocol. After executing this
command, the command line prompt changes to conf-frrp.
Force10 Resilient Ring Protocol (FRRP)
589