CLI Guide

9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command causes the Ring Manager to take ownership of the two ports after
IFM validates the configuration. Ownership is relinquished for a port only when the
interface does not play a part in any control VLAN, that is, the interface does not
belong to any ring.
Related
Commands
show frrp — displays the resilient ring protocol configuration information.
member-vlan
Specify the member VLAN identification numbers.
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
vlan-range Enter the member VLANs using VLAN IDs (separated by
commas), a range of VLAN IDs (separated by a hyphen), a
single VLAN ID, or a combination. For example: VLAN IDs
(comma-separated): 3, 4, 6. Range (hyphen-separated):
5-10. Combination: 3, 4, 5-10, 8.
Defaults none
Command Modes CONFIGURATION (conf-frrp)
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
mode
Set the Master or Transit mode of the ring.
Syntax
mode {master | transit}
To reset the mode, use the no mode {master | transit} command.
588
Force10 Resilient Ring Protocol (FRRP)