CLI Guide

9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
interface
Configure the primary, secondary, and control-vlan interfaces.
Syntax
interface {primary interface secondary interface control-vlan
vlan-id}
To return to the default, use the no interface {primary interface
secondary interface control-vlan vlan-id} command.
Parameters
primary interface Enter the keyword primary to configure the primary
interface then one of the following interfaces and slot/port
information:
• Fast Ethernet interface: enter the keyword
FastEthernet then the slot/port information.
• Port Channel interface: enter the keyword port-
channel
then a number. The range is from 1 to 128.
• 10-Gigabit Ethernet interface: enter the
keyword TenGigabitEthernet then the slot/port
information
secondary
interface
Enter the keyword secondary to configure the secondary
interface then one of the following interfaces and slot/port
information:
• Fast Ethernet interface: enter the keyword
FastEthernet then the slot/port information.
• Port Channel interface: enter the keyword port-
channel
then a number. The range is from 1 to 128.
• 10-Gigabit Ethernet interface: enter the
keyword TenGigabitEthernet then the slot/port
information
control-vlan vlan-
id
Enter the keyword control-vlan then the VLAN ID. The
range is from 1 to 4094.
Defaults none
Command Modes CONFIGURATION (conf-frrp)
Supported Modes Full–Switch
Command History
Version Description
Force10 Resilient Ring Protocol (FRRP)
587