CLI Guide

9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Executing this command without the optional ring-id command clears the
statistics counters on all the available rings. The system requires a command line
confirmation before the command executes. This command clears the following
counters:
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
Example
Dell#clear frrp
Clear frrp statistics counter on all ring [confirm] yes
Dell#clear frrp 4
Clear frrp statistics counter for ring 4 [confirm] yes
Dell#
Related
Commands
show frrp — displays the resilient ring protocol configuration.
debug frrp
Clear the FRRP statistics counters.
Syntax
debug frrp {event | packet | detail} [ring-id] [count number]
To disable debugging, use the no debug frrp {event | packet | detail}
{ring-id} [countnumber] command.
Parameters
event Enter the keyword event to display debug information
related to ring protocol transitions.
packet Enter the keyword packet to display brief debug
information related to control packets.
detail Enter the keyword detail to display detailed debug
information related to the entire ring protocol packets.
ring-id (Optional) Enter the ring identification number. The range is
from 1 to 255.
count number Enter the keyword count then the number of debug
outputs. The range is from 1 to 65534.
Defaults Disabled.
Command Modes CONFIGURATION (conf-frrp)
Force10 Resilient Ring Protocol (FRRP)
585