CLI Guide

Aggregator ports that you manually configured for VLAN membership in stacking mode retain their VLAN

configuration in standalone mode.

To restore the default auto-VLAN mode of operation (in which all ports are members of all 4094 VLANs)

on a port, enter the auto vlan command:

Dell(conf)# interface tengigabitethernet 0/2

Dell(conf-if-te-0/2)# auto vlan

The auto vlan command is applicable only in Standalone mode.

To get the default standalone mode configurations:

• Restore to factory default settings.

Where to Go From Here

You can customize the Aggregator for use in your data center network as necessary. To perform

additional switch configuration, do one of the following:

• For remote out-of-band management, enter the OOB management interface IP address into a Telnet

or SSH client and log in to the switch using the user ID and password to access the CLI.

• For local management using the CLI, use the attached console connection.

• For remote in-band management from a network management station, enter the VLAN IP address of

the management port and log in to the switch to access the CLI.

If you installed the Aggregator in a stack, you can configure additional settings for switch stacking

In case of a Dell Networking OS upgrade, you can check to see that an Aggregator is running the latest

Dell Networking OS version by entering the show version command. To download a Dell Networking OS

version, go to http://support.dell.com.

Refer to the appropriate chapter for detailed information on how to configure specific software settings.

Before You Start