CLI Guide

excluded-address
Prevent the server from leasing an address or range of addresses in the pool.
Syntax
excluded-address [address | low-address high-address]
Parameters
address Enter a single address to be excluded from the pool.
low-address Enter the lowest address in a range of addresses to be
excluded from the pool.
high-address Enter the highest address in a range of addresses to be
excluded from the pool.
Defaults none
Command Modes DHCP
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
hardware-address
For manual configurations, specify the client hardware address.
Syntax
hardware-address address
Parameters
address Enter the hardware address of the client.
Defaults none
Command Modes DHCP <POOL>
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
host
For manual (rather than automatic) configurations, assign a host to a single-address pool.
Syntax
host address
520
Dynamic Host Configuration Protocol